The Proleveling System uses two components, a Leveler and a Cap, to both space and level wall and floor tile installations, virtually eliminating spacing and lippage problems. Unlike almost all other systems, the Levelers can also be used as tile spacers and no tensioning tool is required!

They are available in Cross, Linear (straight) and ?T? shapes with spacer widths of 1 mm, 2 mm, 3 mm and 5 mm. The base of each Leveler has four holes for anchoring between the mortar and tile. The vertical legs of the Leveler rise from the base and act to space the tile. The legs are ?coded? for their millimeter width by the number of holes in one leg.

The legs join to the threaded stem of the Leveler, over which the PRST - Blue Leveler Cap is hand tightened, leveling the tile. The Blue Cap can be threaded from either side to allow leveling of tile from 2 mm (3/32") to 40 mm (15/8") thick and is easily adjusted without any tools.

Once the tile has set, either kick the Blue Cap (or strike with a mallet) in the direction of the joint, or tighten the Blue Cap to cause the stem and leg portion of the Leveler to break loose from the base.

Use PRSSV - Red Removal Cap, to quickly remove the broken portions from the reusable Blue Caps.

Use optional PRSPC - Red Protection Cup, to cover each leveler and prevent any possible tile marking.

Use PRSTT - Clear Leveler Cap, for unobstructed visibility of the grout line.