SGM Mortar Mix Surface Preparation is a computerized blend of special high strength masonry cement, proprietary admixtures, and sand developed to produce a consistent quality mix from batch to batch eliminating costly job-site mixing of these components. SGM Mortar Mix Surface Preparation is conveniently packaged in sixty (60) pound (27.2 kg) and eighty (80) pound (36.3 kg) four-ply polyethylene lined bags and custom palletized for easy handling and movement on the job-site. Use for laying block, stone, brick, tuck-pointing, scratch, brown, or finish coat stucco. SGM Mortar Mix Surface Preparation is ideally suited for use as a substrate for hard surface flooring both interior and exterior applications.
INSTALLATION SURFACE PREPARATION
- Concrete and Plaster Surfaces: All masonry should be twenty-eight (28) days cured and shall be structurally sound, clean, and free of any moisture, wax, oil, paint particles, curing agents, or foreign matter. Remove any liquid curing agents or concrete sealers, followed by a clear water wash.
MIXING
Using a clean mortar box or mechanical mixer, add sufficient cool clean potable water to desired, plastic-like, consistency. For additional strength and performance add Southcrete™ 25 Acrylic Mortar Admix in lieu of water. Do not re-temper mortar mix; discard and prepare fresh mix. Machine mixing is preferred.
- NOTE: All cement-based products have the potential for efflorescence to materialize. This whitish powder or crystalline deposit may become visible before, during, or after installation is completed. Water with a high mineral content can also cause efflorescence.
DIRECTIONS
- READ ENTIRE LABEL AND PIS/MSDS BEFORE USING.
CAUTION
Product is alkaline on contact with water. Use paddle for mixing to avoid splashing into eyes or contact with skin. During mixing or application avoid contact with eyes. In case of such contact, flood eyes repeatedly with water and CALL A PHYSICIAN. Wash thoroughly after handling and before smoking or eating. Do not take internally. CONTAINS FREE SILICA — DO NOT BREATHE DUST. Prolonged exposure to dust may cause delayed lung disease (Silicosis).
APPLICATION
Follow manufacturers suggested installation methods. All materials and effected areas should remain above 40°F / 4.4°C (forty degrees Fahrenheit / 4.4 degrees Celsius) or below 100°F / 38°C (100 degrees Fahrenheit / 38 degrees Celsius) 24-hours prior and 72-hours after placement.
CLEANING
Water is all that is required to remove uncured mortar.
COVERAGE
For Setting Block
Bag Size |
Standard Blocks
8″ x 8″ x 16″
(200 mm x 200 mm x 410 mm) |
Standard Bricks
8″ x 2″ x 4″
(200 mm x 50 mm 100 mm) |
60 lbs.
(22.2 kgs.) |
9 |
28 |
80 lbs.
(36.3 kgs.) |
12 |
37 |
For Thick-Bed Underlayment
Bag Size |
Square Feet at ½ inch |
Square Feet at one (1) inch |
60 lbs.
(22.2 kgs.) |
12 |
6 |
80 lbs.
(36.3 kgs.) |
16 |
8 |
SHELF LIFE
Up to one (1) year from date of manufacture in an unopened, properly store container.
MAINTENANCE
None is required.