For drilling screw anchor holes for shower doors, towel bars and other fixtures. The 1/4" PTC Diamond Crown can be used to drill a pilot hole for PTC Large Diameter Diamond Crowns. Each PTC Small Diameter Diamond Crown is sold with a masonry bit of the same size for drilling in the substrate behind an installed tile. Packaged in a clear plastic tube with instructions.
- 1/4” continuous diamond crown matrix renews a new cutting surface with each cut for faster cuts and longer life.
- Life expectancy of the Small Diameter Crown is 1000+ holes in Porcelain tile with proper usage.
- Holes can be drilled in 20 seconds.
- The PTC Small Diameter Diamond Crowns must be used with a No. PTC-WFA-SDC Water Feed Arbor for Small Crowns. The use of the No. PTC-SG Starting Guide (shown below) is strongly recommended.
- CAUTION: Must use a constant supply of pressurized water, 700-900 rpm drill speed and rotary action only.
- Maximum cutting depth is 1/2".